Kneeboard

The kneeboard is present on both Pilot & RIO 3D models, on the left leg. It also remains fully interactive on the 3D model, without the need to open it via the keybind. The Pilot / RIO 3D models have a default keybinding of RSHIFT + P.

In order to cycle kneeboard configurations, the clamp at the top of the kneeboard must be clicked.

Checklist Configuration

The checklists included provides the crew with Normal Procedure, Attack & Emergency Checklists, as well as aircraft reference data. The checklist procedures are an abridged version of the checklists found in the NAVAIR 01-F14AAP-1B NATOPS Pocket Checklist (for the F-14B Upgrade).

The Checklist configuration can be interacted with the mouse in the cockpit. Navigation works as follows:

• Each of the 11 sections can be quickly skipped to from the front contents page by clicking on the right-hand side section list.
• The pages can also be scrolled manually using the arrows on the bottom navigation bar.
• Return to the contents page via the Home icon on the bottom right.

The 2D version of the Checklist configuration has a default keybinding of RCTRL + C.

Clipboard Configuration

The clipboard configuration provides the crew with the familiar DCS kneeboard on the Pilot & RIO models.

Pages can be cycled in desired direction by clicking on the left or right side of the page.

In order to access the clipboard configuration, the clamp at the top of the kneeboard must be clicked. This will cycle through the tool configurations.

Alternatively, you can change pages through using the regular keybinds, default:

• ] - Page Up
• [ - Page Down

The 2D version of the Clipboard configuration has a default keybinding of RSHIFT + K.

💡 In order to close the 2D checklist tool, make sure to first remove keyboard focus from it by clicking anywhere else in the cockpit.